How to improve the sprayer pump product?

With the progress of society, pumps can be seen everywhere in our daily production and life. With the improvement of scientific and technological level, users have higher and higher requirements for water pump products, such as many models, low prices, high quality, prompt delivery, and good service. Experts pointed out that if water pump manufacturers want to stand on the market, they must increase technological innovation, improve product quality and performance, and enhance core competitiveness. At present, water pumps are used in various industries, including petrochemical pumps, field irrigation submersible pumps, sewage pumps and underground well drainage. sewage pump.

Therefore, as far as the small pump diaphragm pump industry is concerned, the market space for developing water pumps is still relatively broad.

Pump companies should improve mechanical seals, bearings, motors, etc. to increase the added value of products Leakage, need to replace the water pump seal before use.

The replaced water pump mechanical seal leaked due to torn rubber. The pump manufacturer should improve the rubber quality, increase the thickness of the pump mechanical seal rubber, and improve the toughness of the rubber 2. Bearings: Many pumps running 24 hours are faulty and noisy. When they go for repairs, they basically replace the water pump bearings.

At present, the quality of some domestic submersible axial-flow pump bearings is not worse than that of imported bearings. Pump manufacturers should establish a direct procurement network with bearing manufacturers to avoid buying fake and shoddy products 3. Motor: It is an indisputable fact that pump motors steal electricity, not to mention fire motors.

During the commissioning and installation of many pumps, it was found that the current was too large and the motor overheated. After inspection, pump lift is too high or wrong model is selected. Returning to the manufacturer takes time and effort, and adds cost.